jenway 3345, Operating Manual

Page: 11 / 53

SECTION 3
OPERATION
Connect the power supply appropriate to the supply being used to the instrument via the rear panel power
socket. Connect the electrode(s), and ATC probes(s) if used, to the appropriate rear panel sockets.
When power is applied to the instrument the screen will show the mode last used prior to switch off. The
measurement mode will be indicated by displayed units. To change the mode or exit, move to the required
mode by using the arrow keys and then press .
3.1 MENU OPTIONS
mV CONC STORE
CAL RECALL SETUP
mV millivolt mode
CONC concentration mode
STORE used to store the displayed reading
CAL calibration mode - the help key on this menu gives access to last calibration details
RECALL recall mode for stored readings
SETUP used to set up mode specific parameters, instrument and clock set up parameters
pH CONC STORE
ABS RECALL SETUP
pH pH mode
CONC concentration mode
STORE used to store the displayed readings
ABS absolute or relative millivolt mode selection
RECALL recall mode for stored readings
SETUP used to set up mode specific parameters, instrument and clock set upparameters
pH mV STORE
KNOWN ± SAMPLE ±
CAL RECALL SETUP
pH pH mode
mV millivolt mode
STORE used to store the displayed reading
KNOWN ± known addition/subtraction mode
SAMPLE ± sample addition/subtraction mode
CAL calibration mode - the help key on this menu option gives access to last
calibration details
RECALL recall mode for stored readings
SETUP used to set up mode specific parameters, instrument and clock set up parameters
3345/REV A/08-99
8