5
•
Select "SMPS-640" from the device list when it appears on your device
screen. If required, enter the pass code “0000” to pair (link) the unit with your
device.
•
After successfully pairing (linking) the Bluetooth enabled device the
Bluetooth Status Indicator
will be flashing slowly and a short beep will heard.
2. Turn on the unit, 2 melodies will heard. The unit is searching the last paired device.
Once it is found, the
Bluetooth Status Indicator
will be flashing slowly.
3. After successfully pairing (linking), you can begin playing music from your
Bluetooth enabled device wirelessly to the speaker.
4. Press the
/ Volume - Button
on the speaker to adjust to the desired
volume level.
5. After selecting your favorite song, press
Play / Pause
Button
on the unit to
play or pause the playback song.
6. Press
or
button to skip to the previous or next song.
7. Press and hold the
or
button for fast reverse or fast forward during
playback.
8. If the unit need to pair with another Bluetooth device. Press and hold the
Play /
Pause
Button
for 4~5 seconds. The
Bluetooth Status Indicator
will be
flashing rapidly and 2 short beeps will heard, the unit will goes into
Pairing/Discoverable mode again. Repeat last 2 steps on point 1 above.
Notes:
1. Refer to manual of your cell phone, tablet PC, computer or other Bluetooth
enabled devices for Bluetooth operation since it may vary from model to
model.
2. If your Bluetooth enabled device does not support A2DP profile, it will not play
the music through the speaker, even if paired (linked).
3. If you are pairing (linking) your computer to the unit using Bluetooth, you may
need to set the speaker as your computer’s default sound device.
4. If the SMPS-640 is left idle for about 3 minutes without linking to any Bluetooth
enabled device, it will automatically turn off to save battery power.
5. The Bluetooth enabled device and the SMPS-640 should be operated in
the same room for best operation.
Using the SMPS-640 as a Hands-free Bluetooth Speakerphone
1. Link your cell phone to the SMPS-640 via Bluetooth as described above.
2. When receiving an incoming call on your cell phone, tap the
Phone Button
on the speaker to switch the incoming call from cell phone to the SMPS-640. Two
short
beep sounds will be heard confirming the call is being answered. Complete
your call using the built-in microphone and speaker on the SMPS-640.
3. Adjust the volume control on the speaker obtain the desired sound level.
4. To end the call, just tap the
Phone Button
again on the SMPS-640. A short
beep sound will be heard and the call will end. If you were playing music from your
cell phone to the SMPS-640 before answering the call, the music will
automatically resume playing when you hang up.
5. To ignore an incoming call, simply press
Phone Button
twice on the speaker,
two short beeps will be heard and the call will be ignored.
Hang up with the SMPS-640
A quick press on the
Phone Button
will end the call in progress. A short beep tone
will be heard from the speaker confirming the call has ended.
Redialing the last number with the speaker
Tapping the speaker
Phone Button
twice and a short beep will be heard. The
