Jensen JiLS-525iB, User Manual

Page: 10 / 24

GETTING STARTED
POWER SUPPLY SOURCES
This Bluetooth Docking Music System operates using the included AC Adaptor with 5V
3500 mA (center-positive) output and is compatible with standard 120V~ 60Hz AC household
power. This unit also requires 1 x CR2032 Lithium battery (included) for clock backup during
power outage.
CONNECTING THE UNIT TO THE AC ADAPTOR POWER
Plug the AC Adaptor into the DC Jack on the back of unit. Plug the adaptor into a standard
120V~ 60Hz AC outlet.
Note: Do not use a different AC adaptor other than the one included. Your Apple device may
fail to charge and you could damage the dock and/or the Apple device that is docked. A
fire hazard can also occur due to system overloading.
CLOCK SETTING / MEMORY BATTERY BACK-UP
A backup battery compartment is located at rear of the unit.
1. Loose the battery compartment screw.
2. Open the battery compartment lid.
3. For the first time use: just remove the insulation tag.
For battery replacement: install a DC 3V CR2032 type Lithium battery (with the polarity
plus side facing up).
4. Close the battery compartment lid.
5. Screw tight the compartment lid.
REMOTE CONTROL
The remote control works on one 3V type CR2025 lithium battery (Included).
Remove the insulation tab from the battery compartment to activate the remote before first
use.
When the operation of the remote control becomes intermittent or the effective distance
is significantly decreased, replace the original battery with a new type CR2025 3V lithium
battery as follows:
1. Unlock and slide out the battery holder from the remote control case.
2. Replace the weak/dead battery with a new one. Be sure the battery is installed correctly.
The remote will not work if the battery is installed with wrong polarity.
3. Insert the battery holder back into the battery slot.
8