E-6
POWER SOURCE (AC ADAPTOR ONLY)
The JCR-212 is powered by an external 120V AC adaptor with an output of
AC ~ 5V / 400mA.
The unit is also equipped with a battery back-up system for the clock that is powered by
1 x CR2025 lithium battery (not included).
POWER CONNECTION
1. Plug the cord of the power adaptor into the AC IN JACK (#17) located on the back
of the JCR-212.
2. Plug the power adaptor into a household wall socket. The unit is powered up and in
standby mode when you see the display turn on and begin flashing.
Battery Back-up system
•
This radio is equipped with a battery back-up system
located on the back of the unit that requires 1 x
CR2025 lithium battery (not included).
•
Remove the screw that holds the battery compartment
cover in place, and then remove the BATTERY
COMPARTMENT COVER (#15). Insert a CR2025
battery (not included) into the battery compartment
and make sure the positive and negative (+ or -) sides
of the batteries are in contact with the corresponding
terminals in the battery compartment. The battery
should be inserted under the 2 positive contact plates
as shown on the right. Replace the BATTERY
COMPARTMENT COVER (#15) and replace the screw.
•
If a power outage occurs the display will turn off and the back-up battery will
automatically retain the clock and alarm settings.
•
When replacing the battery, do not disconnect the power adaptor otherwise all
clock and alarm settings will be lost.
Note:
The unit will still operate without the back-up battery installed, but the time and alarm
settings will be lost and have to be reset in the event of a power interruption or failure.
BATTERY WARNING
DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD
This product contains a coin/button cell battery. If the coin/button cell battery is
swallowed, it can cause severe internal burns in just 2 hours and can lead to death.
Keep new and used batteries away from children. If the battery compartment does not
close securely, stop using the product and keep it away from children.
If you think batteries might have been swallowed or placed inside any part of the body,
seek immediate medical attention.
STANDBY MODE
Standby Mode is when the unit is first plugged into an AC power source (display
flashing) or after all the settings has been made and the time is showing on the display.
Standby mode is also enabled when the Radio is off, no buttons are pressed and no
alarms are sounding.
