9
BATTERY REPLACEMENT
When the battery becomes weak, the operating distance of
the Remote Control is greatly reduced and you will need to
replace the Lithium battery.
1. Remove the battery compartment from bottom of the
Remote Control.
2. Install 1 “CR2025” Lithium battery with the positive side
facing up.
3. Replace the battery compartment.
IMPORTANT:
Be sure that the battery is installed correctly. Wrong polarity may damage the
Remote Control and void the warranty.
USING THE REMOTE CONTROLLER CORRECTLY
Point the Remote Control at the SENSOR located on the front of the System.
The function of the remote buttons are the same as the corresponding controls on the
main unit.
The performance of the infrared SENSOR may be degraded causing unreliable
operation if there is a strong ambient light source in the same room.
The recommended effective distance for remote operation is about 10-15 feet.
CLOCK SETTING
The following steps can be accomplished by using either the remote or controls with the
same function on JMC-200. For example the current time is set at 12:30 PM.
1. Press the CLK.ADJ Button when the player is in Standby mode.
2. Press the
and
button repeatedly to adjust the hour and minute until the
desired time is displayed.
NOTE:
Be sure to observe the PM indicator to make sure that the time is set correctly for AM or
PM. If the PM indicator is 'On', the time displayed is "PM". If the PM indicator does not
light, the time displayed is "AM ".
3. Press the CLK.ADJ button to confirm your setting.
NOTE: The Player will exit the Clock Setting mode automatically if no button is being
pressed in a period of about 10 seconds.
