Remove all balls from he hopper area
and remove the two philips headed
screws holding the block off plate to
the metal housing.
After removing the block off plate,
remove the ball agitator by removing
the single philips head screw in the
middle of the assembly remember
the orientation because the ball
agitator is notched to only go one the
shaft one way.
Problem: Balls do not dispense when playing the game either with the "game with ball function" or "extra ball"
function. First step is to check the hopper and have sure there is suffient balls in the hopper. Secondly is to check for a
ball jam. Before pulling balls out of the hopper first power down the game, then remove all balls from the hopper. If
there is a ball jammed, remove damaged ball from hopper and restart game. If ball is jammed further in the game
follow steps below. Please contact JET technical support for advise on what could be causing the problem.
Only proceed
with the following instructions after you have contacted JET and are directed to do so.
Step # 2
Clearing ball hopper system
CLEANING A BALL JAM FROM THE HOPPER SYSTEM
Step # 1
Clearing ball hopper system
Jennison Entertainment Technologies
Power Pong Service Manual
Page 37
