Installing the player console
To begin installing the player console, first open the playfield access
door with the supplied key in the spare parts box, and feed the eight
pin molex connector through the access hole on the front side of the
cabinet.
After installing the side cups, connect the six pin molex connector
making sure no pins are pushed out durring installation. Then using
the flexible wire retainer alreay installed inside the cabinet secure
the wire harness above the access door.
Step # 14
INSTALLATION INSTRUCTIONS
Step # 13
Installing the side cups
Installing the player console
Using a short handled philips headed screw driver install the
supplied machine screws to the player console from inside the main
cabinet, be careful not to over-tighten the screws. Then connect the
eight pin molex connector making sure all pins inside the connector
are secure.
Step # 15
Check Box When This Step is Complete
Check Box When This Step is Complete
Check Box When This Step is Complete
Jennison Entertainment Technologies
Power Pong Service Manual
Page 17
