8
3. Install all burner caps and burner bases.
Burner installation:
1. Align the arrow on the burner base with the post on the orifice
holder, then place it onto the orifice holder. This will aid in
aligning the notch in the burner base with the igniter
electrode.
2. Install burner cap onto the burner base by aligning the burner
cap slots (4) with the burner base tabs (4).
Install surface grates:
The surface grates are positioned correctly when the thick ribs
form a frame around the outer edge and the thin ribs are located
across the middle. All burners will be centered with the burner
openings in the grates. See the following illustration.
NOTE: The end grates are different than the center grate. Do not
use the end grate in the center grate position.
3. Plug into a grounded 3 prong outlet.
Complete Installation
Electronic Ignition System
Check Operation of Surface Burners
1. Push in and turn the surface burner control knobs to the “HI”
position.
The surface burner flame should light within 4 seconds. The
first time a surface burner is lit, it may take longer that
4 seconds to light because of air in the gas line.
2. Check the flame on “HI” for a blue color. It should be clean
and soft in character. No yellow tip, blowing or lifting of flame
should occur. Occasional orange flashes are normal and
reflect different elements in the air or gas.
3. Repeat at “LO” position.
4. Check the burner “ON” light for each burner
5. After verifying the proper burner operation, turn the control
knobs to “OFF.”
If burners do not light properly:
■
Turn surface burner control knob to the “OFF” position.
■
Check that the power supply cord is plugged in and the
circuit breaker has not tripped or the fuse blown.
■
Check that the gas shutoff valves are set to the “open”
position.
■
Check that burner caps are properly positioned on burner
bases.
Recheck operation of surface burners. If a burner does not light
at this point, contact your dealer or authorized service company
for assistance.
A. Gas tube opening
B. Burner cap slot (4)
C. Burner cap
D. Burner base
E. Burner base tab (4)
F. Burner base notch
G. Orifice holder
H. Igniter electrode
A. Thick ribs
B. Thin ribs
C. End grates
D. Center grate
A
B
C
D
E
H
F
G
A
B
A
B
A
A
C
D
C
A. Incorrect
B. Correct
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
A
B
