![Jenn-Air SEL0137247 Installation Instructions And Use & Care Manual Download Page 10](http://html1.mh-extra.com/html/jenn-air/sel0137247/sel0137247_installation-instructions-and-use-and-care-manual_643157010.webp)
10
■
Place the charcoal filter bracket back into position so that all
the holes are aligned with the anchors.
■
Secure 2 screws on the upper bracket slots and one screw
with a flat washer on the lower bracket slot, to secure the
bracket in position.
3
7.
Mount charcoal filter bracket
Prepare for Installation
120 V, 60 Hz
1.
Verify electrical outlet location
■
Ensure grounded 3 prong outlet capable of 120 V, 60 Hz is
available before proceeding.
■
Ensure at least
2
/
5
" (1 cm) gap between bottom of the
charcoal filter bracket to top of the grounded 3 prong outlet.
■
Ensure at least 1
9
/
50
" (3 cm) gap between anchor screw and
the bottom of the grounded 3 prong outlet.
■
Ground 3 prong outlet must be
4
/
5
" (2 cm) shorter in width
than the chimney width.
2.
Remove grease filter
■
Remove grease filters before proceeding.
6.
Drill center hole
■
Drill an 8 mm hole where the center hole is marked and insert
1-8 mm anchor.
5.
Remove bracket
■
Remove the screws (not the anchors) in order to remove the
bracket.