11
Oven will not self-clean.
• Check to make sure the cycle is not set for a delayed start. See pg. 5.
• Check if door is closed.
• Check if control is in Sabbath Mode. See pg. 28.
• Oven may be over 400
°
F. Oven temperature must be below 400
°
F to program a
clean cycle.
Oven did not clean properly.
• Longer cleaning time may be needed.
• Excessive spillovers, especially sugary and/or acidic foods, were not removed prior
to the self-clean cycle.
Oven door will not unlock after
• Oven interior is still hot. Allow about one hour for the oven to cool after the
self-clean cycle.
completion of a self-clean cycle. The door can be opened when the LOCK indicator
word is not displayed.
• The control and door may be locked. See pg. 15.
There are no beeps and
• Oven may be in Sabbath Mode. See page 28.
no display.
Moisture collects on oven
• This is normal when cooking foods high in moisture.
window or steam comes from
• Excessive moisture was used when cleaning the window.
oven vent.
There is a strong odor or light
• This is normal for a new range and will disappear after a few uses. Initiating a clean
smoke when oven is turned on.
cycle will “burn off” the odors more quickly.
• Turning on a ventilation fan will help remove the smoke and/or odor.
• Excessive food soils on the oven bottom. Use a self-clean cycle.
Fault Codes
• The oven may detect a fault during programming or during operation. If a fault is
detected, the message FAULT DETECTED - DISABLE POWER TO CLEAR or FAULT
DETECTED - PRESS ENTER TO TRY AGAIN may appear. Follow directions in the display.
If the fault reappears or does not clear, call an authorized servicer or the toll-free
number in the display.
• If the same operation is attempted
before
having the oven repaired, the message
FEATURE NOT AVAILABLE will appear. The feature will remain inoperable until service
is obtained.
• If the oven is heavily soiled, excessive flareups may result in a fault code during
cleaning. Press the
CANCEL
pad and allow the oven to cool completely, wipe out
excess soil, then reset the clean cycle. If the fault code reappears, contact an
authorized servicer.
Noises may be heard.
• The oven makes several low-level noises. You may hear the oven relays as they go on
and off. This is normal.
• As the oven heats and cools, you may hear sounds of metal parts expanding and
contracting. This is normal and will not damage your appliance.
SABBATH displayed
• Oven is in Sabbath Mode. To cancel, press and hold the
Setup
pad for five
continuously.
seconds.
Cannot add another Favorite.
• Favorites is full. To delete a favorite and add another, see page 26.
PROBLEM
SOLUTION
