Jenn-Air JUCFP242HL11 Owner'S Manual Download

Page: 21 / 60

PRODUCT DATA SHEETS

APPLICATION GUIDELINES

WATER SUPPLY

PARAMETERS

It is essential that operational, maintenance, and

lter

replacement requirements be carried out for the

product to perform as advertised.

Model WF-L200V:

The

lter monitor system measures

the amount of water that passes through the

lter and

alerts you to replace the

lter. When 90 % of the

lter’s

rated life is used, the

lter indicator light changes from

green to yellow.

When 100 % of the

lter’s rated life is used, the

lter

indicator light changes from yellow to red, and it

is recommended that you replace the

lter. Use

replacement cartridge L200V / NL120V, part #4396702.

2014 suggested retail price of $32.99 U.S.A./ $49.99

Canada. Prices are subject to change without notice.

Model

WF-NL120V:

Change the water

lter cartridge

every 6-9 months. Use replacement cartridge L200V

/ NL120V, part #4396702. 2014 suggested retail price

of $32.99 U.S.A./ $49.99 Canada. Prices are subject to

change without notice.

The product is for cold water use only.

Do not use with water that is microbiologically unsafe

or of unknown quality without adequate disinfection

before or after the system.

Refer to the front cover or “Accessories” section for the

Manufacturer’s name, address and telephone number.

Refer to the “Warranty” section for the Manufacturer’s

limited warranty.

Base Grille Water Filtration System

Model WF-L200V capacity 200 gallons (757 liters)
Model WF-NL120V capacity 120 gallons (454 liters)

Tested and certified by NSF International

against ANSI/NSF Standard 42 for the reduction

of Chlorine, Taste and Odor, Particulate Class

lll*; and against ANSI/NSF Standard 53 for the

reduction of Lead, Mercury, Benzene, and

p-dichlorobenzene.

This system has been tested according to ANSI/NSF 42/53 for the reduction of the substances listed below.

The concentration of the indicated substances in water entering the system was reduced to a concentration less than

or equal to the permissible limit for water leaving the system, as specified in ANSI/NSF 42/53.

Chlorine Taste/

Odor Particulate

Class III*

≥

50 %

≥

85 %

1.9 mg/L

49,333/mL

2.0 mg/L ± 10 %

At least 10,000

particles/mL

0.07 mg/L

640 mg/L**

0.06 mg/L

312 mg/L

>75.0 %

98.7 %

>75.0 %

99 %

Lead: @ pH 6.5

Lead: @ pH 8.5

Mercury: @ pH 6.5

Mercury: @ pH 8.5

Benzene

p-dichlorobenzene

0.01 mg/L

0.002 mg/L

0.0050 mg/L

0.075 mg/L

0.14 mg/L***

0.15 mg/L***

0.0059 mg/L

0.0054 mg/L

0.0157 mg/L

0.210 mg/L

0.15 mg/L ± 10 %

0.006 mg/L ± 10 %

0.015 ± 10 %

0.225 ± 10 %

0.0014 mg/L

0.0069 mg/L

0.0009 mg/L

0.0007 mg/L

0.002 mg/L

0.0005 mg/L

0.0011 mg/L

0.0042 mg/L

0.0004 mg/L

0.00043 mg/L

0.00083 mg/L

0.0005 mg/L

99.0 %

95.4 %

84.74 %

87.03 %

87.26 %

99.76 %

99.21 %

97.08 %

92.47 %

91.93 %

87.26 %

99.76 %

Substance

Reduction

Aesthetic Effects

Contaminant

Reduction

NSF Reduction

Requirements

NSF Reduction

Requirements

Average

Influent

Average

Influent

Challenge

Concentration

Influent

Challenge

Concentration

Maximum

Effluent

Maximum

Effluent

Average

Effluent

Average

Effluent

Minimum %

Reduction

Minimum %

Reduction

Average %

Reduction

Average %

Reduction

Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.5 gpm (1.9 Lpm). Pressure = 60 psig (413.7 kPa).
Temp. = 63 °F (17.2 °C).

Water Supply

City or Well

Water Pressure

30 - 120 psi (207 - 827 kPa)

Water Temperature 33 °F - 100 °F (0.6 °C - 37.8 °C)
Service Flow Rate 0.5 GPM (1.89 L/min.) @ 60 psi. (413.7 kPa)

Class III particle size: >5 to <15 um
**Test requirement is at least 10,000 particles/mL of AC Fine Test Dust.
***These contaminants are not necessarily in your water supply. Performance may vary based on local water conditions.
®NSF is a registered trademark of NSF International.