WARNING
!
To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.
Microwave Disassembly Procedures
36
16022821 Rev. 0
©2004 Maytag Appliances Company
Turntable Motor
NOTE: Requires removal of unit from cabinet.
1. Turn off power to the unit at the circuit breaker.
2. Open oven door and microwave door to remove screws
securing trim of unit to the cabinet opening.
NOTE: Place a protective covering on the floor, to avoid
damage to the floor.
CAUTION
!
To avoid risk of property damage and personal injury,
place blocking material underneath the front edge of
the wall oven to prevent unit from tipping forward.
3. Slide unit out of cutout.
4. Remove screws securing microwave to the wall oven
(front trim bracket, back, left and right sides).
5. Tip unit on it’s back.
6. Remove screw securing access panel to bottom of
microwave cabinet.
7. Remove access panel.
8. Disconnect wire terminals from turntable motor.
9. Reverse procedure to reassemble.
Oven Door Removal
1. Open oven door and place door hinge locking device
into the hinge hole of both sides of the oven door.
NOTE: You will have to custom fabricate two hinge
locking device, which needs to be approximately
1/4" thick, 5/8" wide, and at least 1-1/2" long.
Door
Hinge
Locking
Devices
2. While grasping both sides of the oven door, raise the
oven door upward, to release the oven door hinges
from the oven chassis.
3. Reverse procedure to reassemble oven door.
