![Jenn-Air JMW8527DA Series Service Manual Download Page 32](http://html1.mh-extra.com/html/jenn-air/jmw8527da-series/jmw8527da-series_service-manual_642941032.webp)
WARNING
!
To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.
Microwave Disassembly Procedures
32
16022821 Rev. 0
©2004 Maytag Appliances Company
CAUTION
!
To avoid risk of personal injury or property damage this
unit requires a two person lift when lifting unit in or out
of cutout.
Removing and Replacing Unit
1. Turn off power to the unit at the circuit breaker.
2. Open oven door and microwave door to remove screws
securing unit to the cabinet opening.
NOTE: Place a protective covering on the floor, to avoid
damage to the floor.
CAUTION
!
To avoid risk of property damage and personal injury,
place blocking material underneath the front edge of
the wall oven to prevent unit from tipping forward.
3. Pull unit forward out of the cabinet opening.
4. Disconnect or unplug the power cord leading from unit
to fuse box or junction box depending on unit.
5. Reinstall the oven using the installation instructions.
Side Trim(s)
NOTE: Requires partial removal of unit from cabinet.
1. Remove screws securing trim piece(s) to the cabinet.
2. Slide unit out of cutout approximately 6 to 8 inches.
CAUTION
!
To avoid risk of property damage and personal injury,
place blocking material underneath the front edge of
the wall oven to prevent unit from tipping forward.
3. Remove screws securing trim piece to unit chassis.
4. Reverse procedure to reassemble.
Control Panel Assembly
NOTE: Requires removal of unit from cabinet.
1. Turn off power to the unit at the circuit breaker.
2. Open oven door and microwave door to remove screws
securing trim of unit to the cabinet opening.
NOTE: Place a protective covering on the floor, to avoid
damage to the floor.
CAUTION
!
To avoid risk of property damage and personal injury,
place blocking material underneath the front edge of
the wall oven to prevent unit from tipping forward.
3. Slide unit out of cutout.
4. Remove screws securing top wrapper to chassis and
remove top cover.
5. Disconnect wire terminal plug from power control
board.
CAUTION
!
While unplugging electrical connections, pins may be
damaged, use extreme care when disconnecting.
6. Lift upward on control panel assembly and tilt top
portion of assembly towards the front of unit to release
plastic tabs securing assembly.
7. Place control panel assembly on a protected surface.
8. Reverse procedure to reassemble.
Control Board Assembly
NOTE: Requires removal of unit from cabinet.
1. Remove control panel, see “Control Panel Assembly”
procedure, steps 1 through 7.
2. Disconnect terminal plug from control panel.
3. Slide control board holder to the left to release from
control panel.
4. Release both plastic tabs securing control board to
holder and tilt top portion of control board outward to
remove.
5. Reverse procedures to reassemble.