7
High Altitude Conversions
IMPORTANT: You must convert LP gas with LP gas high altitude
kit Part Number W10593220 or Natural gas with Natural gas high
altitude kit Part Number W10593221. If you need to convert LP
gas to Natural gas high altitude or Natural gas to LP gas high
altitude, you must convert the pressure regulator. For this, follow
steps 1-3 of the necessary conversion.
Natural Gas Orifice Spud Chart for High Altitude Conversion
See chart in the “Natural Gas High Altitude Conversion Kit.”
Burner locations
30" (76.2 cm) Models
36" (91.4 cm) Models
5. Remove all burner caps and burner bases. If necessary,
remove the burner ring.
6. To Convert Burners:
■
Insert
7
.0 mm nut driver down onto the gas orifice spud
and remove by turning it counterclockwise and lifting out.
■
Set gas orifice spud aside.
■
Replace with correct Natural gas orifice spud. See the
Natural Gas Orifice Spud Chart.
7. Place LP gas orifice spuds in plastic parts bag for future use
and keep with package containing literature.
8. Replace burner bases and burner caps.
IMPORTANT: Be sure that the electrode aligns with the notch
in the burner base. The igniter electrode is ceramic and could
break during installation of the burner base.
9. Open shutoff valve in the gas supply line. The valve is open
when the handle is parallel to the gas pipe.
A. Left rear burner
B. Center burner
C. Right rear burner
D. Right front burner
E. Left front burner
A. Left rear burner
B. Center rear burner
C. Right rear burner
D. Right front burner
E. Center front burner
F. Left front burner
A
A
B
C
D
E
A
B
C
D
E
F
A. Gas tube opening
B. Burner cap slot (4)
C. Burner cap
D. Burner base
E. Burner base tab (4)
F. Burner base notch
G. Orifice holder
H. Igniter electrode
A. Igniter electrode
B. Orifice holder
C. Orifice spud
A. Burner cap
B. Electrode
C. Burner base
A
B
C
D
E
H
F
G
A
B
C
B
C
A
