17
7.
Put a control knob onto the valve stem of the burner
you want to adjust.
8.
Turn the control knob to LO and, using a butane extension
lighter, light the burner.
9.
Remove the control knob.
10.
Use a 1/8" x 4
1
/
4
" (3 mm x 100 mm) flat-blade screwdriver to
adjust the flame height. Tighten screw to reduce flame
height. Loosen screw to increase flame height.
11.
When finished adjusting the flame height, put a control knob
back onto the valve stem and turn off the burner.
12.
Remove the control knob.
13.
Replace the round gasket.
14.
Repeat steps 6 through 13 for any other burners that
need adjustment.
15.
Lift up on the control console and set it back into place. For
a proper fit, the flange of the control console must hook over
the lip on the front of the range cooktop.
16.
Check that the control console is flush with the top edge
of the range.
17.
Replace the two screws on each side of the control console.
18.
Replace the control knobs.
19.
Replace burner grates.
20.
Test the flame by turning the control from LO to HI,
checking the flame at each setting.
Reinstall Kick Plate
1.
Align shoulder screw mounting holes with shoulder screws
on range.
2.
Push kick plate down against front of range until the top
screw holes are aligned with the mounting holes on the front
of the range.
3.
Reattach screws to the top of the kick plate.
A
B
A. Single flame burner adjustment screw (on right side of valve)
B. Dual flame burner adjustment screw (on left side of valve)
A
B
A. Control console flange
B. Front lip of range cooktop
A
A. Flush with range top
A
B
D
C
A. Kick plate
B. Reattach these screws.
C. Top screw hole
D. Shoulder screw mounting hole
