3
INITIAL INSPECTION
Carefully unpack the unit and accessories. Inspect for damages
made in shipment. If any damage is found, notify your
JENCO
representative immediately. All packing materials should be saved
until satisfactory operation is confirmed.
POWER INPUT
The model 6377MB/6377BEU can be powered by an UL/CE
approved 100 to 240 VAC adaptor as well as 6 “AAA” alkaline
batteries. Check the label on the AC adaptor supplied with the
meter to make sure that the AC line voltage is correct. If the wrong
AC adaptor is supplied, notify your
JENCO
representative
immediately.
INSTALLING THE BATTERIES
To insert the batteries into the meter, follow the procedure outlined
below.
1.
Use a Philip screw driver and unlock the battery cover by
turning the screw driver in the counter clockwise direction.
After unlocking the screw, take off the battery cover (Fig.1)
2.
Replace the old batteries with new ones and install them on
the correct polarity position.
3.
Put the battery cover back on the meter. Use a Philip screw
driver and turn the screw in the clockwise direction to lock the
battery cover.
Figure 1: Battery compartment
