18
I. Save, Recall and Delete Data
1. Saving readings to memory.
a. In the measure modes, press and hold
“Slope/Enter”
key
for 2 seconds to save data. The “ID” icon and number with
the corresponding site number will lit up for a brief moment
to indicate a successful data save. Saving is now complete.
b. If the “Full” will show, this means that all 750 data saving
sites are used up. No new data can be saved until existing
saved data are deleted.
2. Recalling readings from memory.
a. Press
“Mode”
key until the “dAtA rCL” will show. Press
"Slope/Enter"
key to go into “Recall” mode.
b. To view data, press
“Up”
or
“Down”
key to select the
storage site number and displays the corresponding record.
c. Press
“Mode”
key to exit “Recall” mode.
3. Deleting data.
a. Press
“Mode”
key until the “dEL onE” or “dEL ALL” will show.
Then press the
“Slope/Enter"
key to go into the
corresponding “Delete one ” or “Delete ALL” mode.
b. In the “Delete ALL” mode, press the
“Slope/Enter”
and
enters the selection screen. Use the
“Up”
or
“Down”
key to
select YES/no for clearing all stored data. To clear all data,
must select YES and press the
“Slope/Enter”
key. “nonE”
will show after data is completely deleted.
c. In the “Delete one” mode, use
“Up”
or
“Down”
key to select
data to be deleted. Then press
“Slope/Enter”
key to delete.
Deletion is now complete. The next set of saved data will
automatically move up a slot in the storage site.
d. Press
“Mode”
key to exit “Delete” mode.
