JENCO 6309 POT, Operation Manual

Page: 7 / 35

7
NORMAL or CHECK STATUS operation. IF no relay is ON then
the “ NORMAL ” message will be displayed. IF any relay is ON
then the “ CHECK STATUS ” will be displayed.
2. CURRENT OUT - this will display the actual output of the 4-20
mA output. At POWER-ON this will show “ OFF ” for about three
seconds before going to normal operation. After exiting the
Calibration /Setting pages a “
FROZEN ” message will be
displayed for about three seconds before returning to normal
operation.
3. REL or ABS – this text will indicate if the present ORP reading
is ABS olute or REL ative value.
4. annunciator - This will be displayed if Calibration/Setting
pages are password locked , meaning the user will not be able
to change the calibration/setting values unless the correct 4 digit
number has been entered.
5. H , L annunciators - one or both of these annunciators will be
displayed if the left side reading (LARGE FONT DISPLAY)
triggered the respective relay settings. The rightmost character
will indicate RELAY 1 if the display is pH or RELAY 3 if the
display is ORP. The leftmost character will indicate RELAY2 if
the display is pH or RELAY 4 If the display is ORP. If the display
is ORP the annunciators will only indicate the unit selected at the
RELAY/mA option in the ORP CALIBRATION .
6. LARGE FONT DISPLAY - this reading uses the biggest font
and the reading here is the
only one that will affect the analog
output
. You can select the pH or ORP reading only to be shown
here by changing the Transmitter Output (pH LINEAR, pH
ANTILOG or ORP LINEAR) option.
7. H , L annunciators - one or both of these annunciators will be
displayed if the left side reading (MEDIUM FONT DISPLAY)