MODES OF THE METER
1.
pH-AUTOLOCK mode:
The unit will display pH and
temperature with both the “pH”
and the “AUTOLOCK” icons on.
The “WAIT” icon flashes until
the unit detects a stable
reading.
2.
mV- AUTOLOCK mode:
The unit will display mV and
temperature with both the “mV”
and the “AUTOLOCK” icons on.
The “WAIT” icon flashes until
the unit detects a stable
reading.
3.
pH mode:
The unit will display pH and
temperature readings with the
“pH” icon on but “AUTOLOCK”
icon off.
4.
mV mode:
The unit will display mV and
temperature readings with the
“mV” icon on but “AUTOLOCK”
icon off.
OPERATIONAL PROCEDURES
A. Buffer Set Selection
The 6010N meter has two buffer sets: 7.00, 4.01, 10.01pH and 6.86,
4.00, 9.18pH. The meter is factory pre-set at 7.00, 4.01 and
10.01pH.
To change the buffer set, turn off the unit, then press and hold the
“STAND” key while turning on the unit again.
[Note: There is no need to repeat this procedure every time the unit
is power up unless one decides to change the buffer settings.]
6
