Jema Autolifte DWC, User Manual

Page: 7 / 20

– 7 – Jema Autolifte A/S wheel balancer DWC
3.8 Wheel balancing
-
Close the guard.
-
Press the START key.
-
The wheel is accelerated automatically to balancing speed and then braked; displays 3 and 5 read the unbalance values.
-
Displays 1 and 2 read the correction position with LEDs. If all the LEDs are lit, the correction weight must be put at the top
of the vertical axis.
IMPORTANT: An unbalance value reading below 10-12 grams (0.4-0.5 oz) is normally sufficient for good balancing.
With this balancing machine, it is easy to balance to a tolerance of only 5 grams (0.2 oz) or less.
THRESHOLD KEY: FINE
The correction of residual unbalance below 5 grams (0.2 oz) can be read whenever necessary (wheels for special uses) by
pressing this key with the machine at a standstill.
Display 3 and 5 for unbalances below 5 grams (0.2 oz) in normal conditions.
3.8.1 Alu-S Function - How to use ALU-S program.
Select: ALU S (press ALU key to LED-light is on next to the Alu-S program)
• A ↑ ↓ - keys, A1 = Distance from the edge of the machine to the inner track of the rim where glue-grams must be placed.
• B ↑ ↓ - keys, AE = Distance from the edge of the machine to the outer track on the rim where glue-grams must be placed.
• D ↑ ↓ - keys, d1 = Rim diameter measured at the inner track which adhesive glue-grams to be installed and entered. (Usefully
be measured before mounting the wheel on DWC)
• Aluminum is pressed and hold, and D ↑ ↓ - keys, change rim diameter measured at the outermost track on which glue-grams
must be installed. (Can usefully be measured before mounting the wheel on DWC)
• Glue-grams glued on 12 o´clock, at the time that all LED-light is turned on. (12.00.)
3.9 Self calibration methods
-
Fit any wheel to the shaft, even one that is not balanced, although it is advisable to use one with “average” dimensions.
-
Set the exact dimensions of the wheel fitted.
ATTENTION: any error in setting the dimensions will mean that the machine is not correctly calibrated, so all the subsequent
measurements will be faulty until the machine is next calibrated with correct measurements.
-
Press F + C .
-
Until the positioning LED’s change from flashing into steady.
- Press START
- Add a 100 gram weight on the outside in any angular position.
-
Press START .