Page 4
3C Side:
The right side of the meter includes:
A. USB A female port
–
For firmware and system updates (requires a USB stick)
.
B. Micro USB female port
–
For charging and extraction of saved data
.
C. Mini USB female port
–
For charging the battery & running external Datalight II
software
.
D. Charging LED
–
Light when device is charging (off when not charging)
E. On/Off
– Fast Charge:
Turns meter on for use. Turn off to conserve battery or for
faster charging.
3D. Top:
Contains the sensor mount, a
15-Pin D-Sub connector and posts for securing the sensor
to the device. The JEL-2400
is backwards compatible with all “D” style sensors with the
exception of PMT's and SHD Low light level sensors. To connect the sensor, align the
sensor’s male 15 pin connector to the meter’s female connector and apply slight
pressure to insert. To assure proper connection is maintained during testing, tighten
screws on each side of sensor connector.
3E. Quick Setting Guide:
If your meter and sensor were purchased together along with optical calibrations, your
device(s) will arrive with factory pre-programmed optical calibration factors. (See 15B
Manage Calibration Factors for self-programming of calibration factors as needed)
i. Turn on the meter by pushing the On/Off button down into the ( I ) position.
ii. After a short start up menu the Home Screen will appear.
iii. Connect the Sensor/Detector to the top of the meter and secure (See 3D above)
iv. Check the power monitor window in the upper right hand corner to assure
batteries have enough charge to complete testing (see Section 4B for charging
instructions)
v. Select your display style based on user preference (touch ICON to select)
Meter:
Larger numerical values and no graph.
Trend:
Smaller control buttons with optional bar or line graph (see 15
I
to
change chart type).
Tall:
Portrait mode (USB ports and on/off switch on the right).
Wide:
Landscape mode (USB ports and on/off switch on the top).