Installation Instructions Product-Ident: 75181
1 Disassembly of the door card
1.1
Roll down window completely.
1.2
Unscrew screw A - C.
1.3
Remove the molding under the arm rest up to the end of the handle.
1.4
Unclip the lower and lateral edges of the door card and remove the door card upwards.
1.5
Remove the Bowden pull wire out of the door latch lever.
1.6
Unplug central-switch.
1.7
Car door: disconnect the original loudspeaker plugs and dismount the original woofer(not to be used any more)
2 Tweeter installation A-pillar - original mount without mounting device
2.1
Dismount the original speaker grill of the A-pillar and the original tweeter. Unplug the connecting cables. (No more need of the
original connecting cable and tweeter).
2.2
Remove the tweeter out of the mounting holder:--- >bayonet catch: turn to the right and pull
out of the holding device (by means of the screw) - no more need of the mounting device)
2.3
Adjust the JEHNERT-tweeter in the original cut-out and affix with hot melt adhesive or silicone
on the back side.
2.4
Adapt the JEHNERT-tweeter cable with the speaker cable (1,5-4qmm), lead the cable up to
where the crossover is installed in the doorboard.
2.5
Reinstall the original speaker grill.