7. installation of the door-lining onto the the car doors
7.1. put the door-lining into the upper sealing of the car door
7.2. fit it in contrary order of succession as described on page no. 3
7.3. cut out the moisture protection foil (u-form) and stabilize the lateral cutting
edges in order to avoid vibration noise ( e.g. use a packing tape)
1. use the precisely aligned panel as template in order to mark fastening points 1- 9:
•
mark the fastening points
1-3_ premounted in the panel:
pressing the panel to the door lining leaves visible impressions of the screws
•
mark the fastening points
4-8:
use a thin awl to set the marks on the door-lining
2. draw the speakers’ cut-outs onto the door-lining.
3. remove the panel again.
cut out holes for loudspeakers along the marking (see fig.)
with a compass saw.
4. use a 6mm drill for the screws according to the marks set before
5. Screw in the M4-screws supplied with. Affix the door build to the door-lining.
Screw all 9 x M4-screws only hand-tight .
Secure all screws with the washers and nuts.
6. check again for precise fitting and tighten screws.
All cutting edges of the panel must fit to the door lining snugly
all around without gap
cut-outs of the door lining
additional cut- out
for subwoofer
4. Handling of door lining / Panel installation - Fastening
45146 - BMW 3 E 36 Sedan / Touring
- 9 -
© JEHNERT SOUND DESIGN
45146 - BMW 3 E 36 Sedan / Touring
- 6 -
© JEHNERT SOUND DESIGN
�
✍
✍
1
original cutout
(possibly to be
enlarged)
3
9
M 4 x 30
M 4 x 30
2
4
M 4 x 30
5
M 4 x 30
8
7
M 4 x 30
6
M 4 x 30
M 4 x40
already
mounted
M 4 x50
already
mounted
✍
✍
