9
USER MANUAL v1.2
JEFPDB0550
550W
Bench Drill • 230V ~50Hz
www.jeffersontools.com
Drilling
1. Ensure the bench drill is switched off and disconnected from the power supply.
2. Loosen the jaws of the chuck with the chuck key by turning in an anti-clockwise direction and insert the selected drill bit into the as far as it
will go.
3. Insert the chuck key into 1 of the 3 locating holes and tighten until the drill bit is secure.
4. Select your drilling depth and secure the depth stop lock knob in position.
5. Turn the bench drill on by pressing the green button on the switch
(Fig.34).
6. Adjust the table to your desired position.
7. Slowly rotate the feed wheel handles to bring the drill bit down towards the table and into your workpiece.
After drilling a hole, release the feed wheel handles slowly to return the chuck to its original position.
8. Continue the operation until the task is completed.
9. When your work is complete, switch the bench drill off by pressing the red button on the switch.
Maintenance
For maximum performance, it is essential that the bench drill is properly maintained. Always inspect it before use. Any damage should be re-
paired, and faults fixed immediately. Always remove the plug from the power supply before carrying out any adjustment, servicing or maintenance
on this equipment. Contact your nearest Jefferson Dealer if any faults or damage is found.
Monthly Maintenance
1. Check tightness of mounting bolts, and head and column securing set screws.
2. Check the drive belt for wear, and replace if frayed or damaged.
3. Blow out with compressed air, or vacuum clean out, any dust that may have accumulated in the motor fan vents.
4. Apply a thin coat of wax paste or light oil to the table and column, for lubrication, and to help prevent corrosion.
5. If the mains lead is damaged in any way, it should be replaced immediately.
Lubrication
•
All bearings are packed with grease at the factory and require no further lubrication.
•
Occasionally, lubricate the quill shaft assembly and rack with light oil if required.
After Use
•
Remove all swarf from the machine and thoroughly clean all surfaces.
•
Components should be kept dry, with machined surfaces lightly oiled.
•
Always remove drill bits, and store in a safe place.
Parts & Servicing
For Jefferson approved replacement parts contact your
nearest dealer or contact Jefferson tools
Telephone:
+44 (0)1244 646 048
Fax:
+44 (0)1244 241 191
Email:
