Jefferson JEFARIVT02H, User Manual

Page: 7 / 16

7
USER MANUAL
v1.1
JEFARIVT02H
AIR-HYDRAULIC BLIND RIVETER
www.jeffersontools.com
Fig.4
Fig.5
Fig.6 Fig.7
Fig.8
Fig.9
Operation
Ensure the air valve is in the closed position before connecting the air
supply:
•
Open the shut-off valve by sliding the knurled ring upwards as shown
in the diagram to the right.
•
Insert the desired size rivet into the nozzle, ensuring the appropriate
nozzle is fitted first.
•
Insert the rivet into the workpiece as far as it will go and squeeze the
trigger.
•
The rivet will be compressed and the spent mandrel will be sucked into
the spent mandrel bottle.
•
When the spent mandrel bottle is full, close the shut-off
valve, unscrew, empty and replace as shown in
Fig.4
.
MAINTENANCE
IMPORTANT:
Ensure you disconnect the tool from the air supply system before attempting any maintenance.
General Maintenance
•
Ensure that the riveter is kept in good clean condition. Check condition prior to use. Do not use the equipment if
damage is detected. Contact Jefferson tools for advice on repair and replacement parts.
•
Maintain the tool with care.
•
Keep the equipment well oiled for optimum performance.
Lubrication
• Lubricate the air tool daily with a suitable high quality air tool oil
(for example SAE 10). Please refer to the parts diagram shown on
pg.10 for reference.
• Unscrew and remove the frame head (Part #38) and cylinder cap
(Part #1A) using 2x Ø5.1mm rods as shown in
Fig.5.
Remove the
air piston (Part #7A). Using the oil can supplied, fill the reservoir
with oil until the oil level reaches the o-ring (Part #18). Inspect,
clean or replace the oil seal as required during this procedure.
• Re-fit the cylinder cap and reassemble the jaw housing and
adjust the length to match the spanner gauge (Part #63) and fix
the frame head as shown in
Fig.9
.
Jaw Replacement
•
After a period of use the jaws on the riveter will wear and
require replacement.
•
To replace, first remove the nozzle and frame head using
the spanners supplied as shown in
Fig.6.
•
Undo and remove the jaw housing from the jaw housing (
Fig.7 - Fig.8)
•
Remove the worn jaws and replace with a new set. If the
jaw pusher and spring fall out, put the spring back first and
then the jaw pusher followed by the jaws.
•
Fit the frame head and tighten.
•
When the jaws are replaced check that the jaw distance
from the main body is 84mm using the guide on the
spanner as shown in
Fig.9
.
Oil Level