Jefferson Tools, Herons Way, Chester Business Park, Chester, CH4 9QR, United Kingdom
T:
+44 (0) 1244 646 048
F:
+44 (0) 01244 360 314
E:
www.jeffersontools.com
7. Cleaning & Maintenance
It is very important that the tank, material hose and spray gun are cleaned thoroughly after each use.
WARNING:
Always ensure that the air supply is turned off and bleed off any excess pressure in the paint tank by pulling the safety valve ring before
loosening the thumb screw and clamps to remove the lid.
1.
Turn off the main air supply to the tank, remove all pressure from the tank be pulling the safety valve ring until the pressure level bleeds down.
2.
Turn the -T-Handle adjusting screw on the regulator counter-clockwise until no spring tension is felt.
3.
Loosen the thumb screws, tip clamps and tip the tank lid down to one side. Loosen the spray gun sun air cap retaining ring approximately three
turns then turn on the main air supply.
4.
Cup a cloth over the air cap on the spray gun and pull the trigger. This will help to force the material back through the hose into the tank.
5.
Empty and clean the tank and parts which have come into contact with the spraying materials.
6.
Use a suitable non-corrosive solvent to clean the tanks and parts.
7.
Replace the lid and secure clamps, reattach the air supply and spray the solvent through the system until it is fully rinsed and sprays clear.
8. Troubleshooting
