Jeep Grand Cherokee SRT 2018, Owner'S Manual, Page: 165 / 666

To Cancel
The following conditions will cancel the Normal
(Fixed Speed) Cruise Control without clearing
the memory:
•
The brake pedal is applied.
•
The CANC button is pushed.
•
The Electronic Stability Control/Traction Con-
trol System (ESC/TCS) activates.
•
The vehicle parking brake is applied.
•
The braking temperature exceeds normal
range (overheated).
•
The gear selector is removed from the DRIVE
position.
•
The driver switches ESC to full-off mode.
To Resume Speed
To resume a previously set speed, push the
RES button and release. Resume can be used
at any speed above 19 mph (30 km/h).
To Turn Off
The system will turn off and erase the set speed
in memory if:
•
The Normal (Fixed Speed) Cruise Control
on/off button is pushed.
•
The ignition is turned OFF.
•
You engage Four-Wheel Drive Low.
•
The Adaptive Cruise Control (ACC) on/off
button is pushed.
PARKSENSE REAR PARK
ASSIST — IF EQUIPPED
The ParkSense Rear Park Assist system provides
visual and audible indications of the distance
between the rear fascia and a detected obstacle
when backing up, e.g. during a parking maneuver.
If your vehicle is equipped with an Automatic
Transmission, the vehicle brakes may be auto-
matically applied and released when performing a
reverse parking maneuver if the system detects a
possible collision with an obstacle.
NOTE:
•
The driver can override the automatic braking
function by pressing the gas pedal, turning
ParkSense off via ParkSense switch, or
changing the gear while the automatic brakes
are being applied.
•
Automatic brakes will not be available if ESC
is not available.
•
Automatic brakes will not be available if there
is a faulted condition detected with the
ParkSense Park Assist system or the Braking
System Module.
•
The automatic braking function may only be
applied if the vehicle deceleration is not
enough to avoid colliding with a detected
obstacle.
•
The automatic braking function may not be
applied fast enough for obstacles that move
toward the rear of the vehicle from the left
and/or right sides.
•
The automatic braking function can be enabled/
disabled from the Customer-Programmable Fea-
tures section of the Uconnect System.
•
ParkSense will retain its last known configu-
ration state for the automatic braking function
through ignition cycles.
The automatic braking function is intended to
assist the driver in avoiding possible collisions
with detected obstacles when backing up in
REVERSE gear.
NOTE:
•
The driver is always responsible for control-
ling the vehicle.
•
The system is provided to assist the driver
and not to substitute the driver.
•
The driver must stay in full control of the
vehicle’s acceleration and braking and is re-
sponsible for the vehicle’s movements.
Refer to “ParkSense System Usage Precau-
tions” for limitations of this system and recom-
mendations.
ParkSense will retain the last system state (en-
abled or disabled) from the last ignition cycle
when the ignition is changed to the ON/RUN
position.
ParkSense can be active only when the gear
selector is in REVERSE. If ParkSense is en-
abled at this gear selector position, the system
will remain active until the vehicle speed is
increased to approximately 7 mph (11 km/h) or
162