Jeep Grand Cherokee SRT 2018, Owner'S Manual, Page: 24 / 666

Skin oils may cause battery deterioration. If
you touch a battery, clean it with rubbing
alcohol.
4. To assemble the key fob case, snap the two
halves together.
Programming Additional Key Fobs
Programming the key fob may be performed by
your authorized dealer.
Request For Additional Key Fobs
NOTE:
Only key fobs that are programmed to the
vehicle electronics can be used to start and
operate the vehicle. Once a key fob is pro-
grammed to a vehicle, it cannot be programmed
to any other vehicle.
WARNING!
•
Always remove the key fobs from the ve-
hicle and lock all doors when leaving the
vehicle unattended.
•
Always remember to place the ignition in
the OFF mode.
Duplication of key fobs may be performed at an
authorized dealer. This procedure consists of
programming a blank key fob to the vehicle
electronics. A blank key fob is one that has
never been programmed.
NOTE:
•
When having the Sentry Key Immobilizer
System serviced, bring all vehicle keys with
you to an authorized dealer.
•
Keys must be ordered to the correct key cut
to match the vehicle locks.
NOTE:
Black keys (6.4L) must be replaced with black
keys and Red Keys (6.2L) must be replaced with
Red Keys.
IGNITION SWITCH
Keyless Enter-N-Go — Ignition
This feature allows the driver to operate the
ignition switch with the push of a button as long
as the key fob is in the passenger compartment.
The Keyless Push Button Ignition has several
operating modes that are labeled and will illumi-
nate when in position. These modes are OFF,
ACC, RUN, and START.
NOTE:
If the ignition switch does not change with the
push of a button, the key fob may have a low or
dead battery. In this situation, a back up method
can be used to operate the ignition switch. Put the
nose side (side opposite of the emergency key) of
the key fob against the ENGINE START/STOP
button and push to operate the ignition switch.
The push button ignition can be placed in the
following modes:
OFF
•
The engine is stopped.
•
Some electrical devices (e.g. Central locking,
alarm, etc.) are still available.
ACC
•
Engine is not started.
•
Some electrical devices are available.
RUN
•
Driving position.
•
All the electrical devices are available.
START
•
The engine will start.
START/STOP Ignition Button
21