Jeep Grand Cherokee SRT 2014, Operating Manual, Page: 229 / 345

point indicator lamp 3 will go solid. If during
the height change to Entry/Exit Mode, the
vehicle speed exceeds 15 mph (24 km/h),
the height change will be paused until the
vehicle speed either goes below 15 mph
(24 km/h) and the height change continues to
Entry/Exit
Mode, or exceeds 25 mph
(40 km/h) and the vehicle height will return to
NRH. Entry/Exit Mode may be selected while
the vehicle is not moving provided that the
engine is still running and all doors remain
closed.
•
Transport Mode - No indicator lamps will be
illuminated. Customer driving will disable
Transport Mode.
•
Tire/Jack Mode - indicator lamps 3 and 6 will
be illuminated. Customer driving will disable
Tire/Jack Mode.
•
Wheel Alignment Mode - indicator lamps 3
and 4 will be illuminated. Customer driving
will disable Wheel Alignment Mode.
ON-ROAD DRIVING TIPS
Utility vehicles have higher ground clearance
and a narrower track to make them capable of
performing in a wide variety of off-road applica-
tions. Specific design characteristics give them
a higher center of gravity than ordinary cars.
An advantage of the higher ground clearance is
a better view of the road, allowing you to
anticipate problems. They are not designed for
cornering at the same speeds as conventional
two-wheel drive vehicles any more than low-
slung sports cars are designed to perform sat-
isfactorily in off-road conditions. If at all pos-
sible, avoid sharp turns or abrupt maneuvers.
As with other vehicles of this type, failure to
operate this vehicle correctly may result in loss
of control or vehicle rollover.
OFF-ROAD DRIVING TIPS
NOTE:
Prior to off-road driving, remove the front air
dam to prevent damage. The front air dam is
attached to the lower front fascia with seven
quarter turn fasteners and can be removed
by hand. The front license plate bracket
must be removed first if equipped.
Quadra-Lift™ – If Equipped
When off-roading, it is recommended that the
lowest useable vehicle height that will clear the
current obstacle or terrain be selected. The
vehicle height should then be raised as required
by the changes in terrain.
The Selec-Terrain™ switch will automatically
change the vehicle to the optimized height
based on the Selec-Terrain™ switch position.
The vehicle height can be changed from the
Front Air Dam
1 — Front Bumper
2 — Front Air Dam Fasteners
225