Jeep Compass 2023, Owner'S Manual

Page: 261 / 304

SERVICING AND MAINTENANCE 259
Replacing Exterior Bulbs
Turn Signal Light/Position Lights (Base)
To replace the bulbs proceed as follows:
1. Open hood.
2. Reach behind headlamp near the radiator.
3. Remove the electrical connectors.
4. For the turn signal bulb, rotate in a counterclockwise
direction and remove the bulb and bulb socket.
Pull the bulb axially to remove it from the socket.
5. Install the bulb and sockets and rotate them
clockwise making sure that it is properly locked.
6. Reconnect the electrical connectors.
7. Close hood.
Front Fog Lights (Base)
To replace the bulbs proceed as follows:
1. Turn the front wheels completely.
2. Remove the wheel liner.
3. By pushing the electrical connector tab remove the
electrical connector.
4. Rotate the bulb counterclockwise, and then replace
the bulb.
Fog Lamp Bulb
5. Insert the new bulb in the socket, making sure the
bulb is locked into place.
6. Reconnect the electrical connector.
7. Reinstall the wheel liner.
Side Indicators
The Side Indicators are LED. See an authorized dealer for
replacement.
Rear Body Side Tail Lamps
Contain the following:

Position lights

Stop lights

Direction indicator
To replace the bulbs proceed as follows:
1. Open the liftgate.
2. Using a suitable tool remove fasteners covering the
screws.
3. Disconnect the electrical connector by pushing the
release.
4. Remove the rear body side tail lamp, sliding it away
from the back of the vehicle.
Body Side Tail Lamp
5. Replace the bulb as necessary by turning and
removing the bulb housing.
WARNING!
Carry out the operation of replacing lamps only with the
engine off. Also make sure that the engine is cold, to
avoid the danger of burns.
1 — Rear Body Side Tail Lamp
2 — Ball Stud
8
23_MP_OM_EN_USC_t.book Page 259