GETTING TO KNOW YOUR INSTRUMENT PANEL
127
What to do when an electrical load reduction action
message is present (“Battery Saver On” or “Battery Saver
Mode”)
During a trip:
• Reduce power to unnecessary loads if possible:
• Turn off redundant lights (interior or exterior)
• Check what may be plugged in to power o12 Volts,
150W, USB ports
• Check HVAC settings (blower, temperature)
• Check the audio settings (volume)
After a trip:
• Check if any aftermarket equipment was installed (addi
-
tional lights, upfitter electrical accessories, audio systems,
alarms) and review specifications if any (load and Ignition
Off Draw currents).
• Evaluate the latest driving cycles (distance, driving time
and parking time).
• The vehicle should have service performed if the message
is still present during consecutive trips and the evaluation
of the vehicle and driving pattern did not help to identify
the cause.
TRIP COMPUTER
Push and release the
up
or
down
arrow button until the Trip
A or Trip B icon is highlighted in the instrument cluster
display (Toggle
left
or
right
to select Trip A or Trip B). Push
and release the
OK
button to display the Trip information.
Trip A
• Shows the total distance traveled for Trip A since the last reset.
• Shows the elapsed time traveled for Trip A since the last reset.
Trip B
• Shows the total distance traveled for Trip B since the last reset.
• Shows the elapsed time traveled for Trip B since the last reset.
Elapsed Time
Shows the total elapsed time of travel since the last reset
when the ignition switch is in the ACC position. Elapsed
time will increment when the ignition switch is in the ON/
START position.
To Reset A Trip Function
Reset will only occur while a resettable function is selected
(highlighted). Push and hold the
OK
button to clear the
resettable function being displayed.
3
2020_JEEP_MP_OM_USA=GUID-E8C7E66B-DF9E-40BA-9B4A-03D9C7E22684=1=en=.backup.book Page 127