Jeep Cherokee 2009, Operating Information Manual

Page: 57 / 223

accept the call. To reject the call, press and hold
the “Phone” button until you hear a single beep
indicating that the incoming call was rejected.
Answer or Reject an Incoming Call - Call
Currently in Progress
If a call is currently in progress and you have
another incoming call, you will hear the same
network tones for call waiting that you normally
hear when using your cell phone. Press the
“Phone” button to place the current call on hold
and answer the incoming call.
NOTE:
The UConnect
!
system compatible phones in
the market today do not support rejecting an
incoming call when another call is in progress.
Therefore, the user can only answer an incom-
ing call or ignore it.
Making a Second Call While Current Call in
Progress
To make a second call while you are currently on
a call, press the “Voice Recognition” button and
say
"
Dial
"
or
"
Call
"
followed by the phone number
or phonebook entry you wish to call. The first call
will be on hold while the second call is in progress.
To go back to the first call, refer to
"
Toggling
Between Calls.
"
To combine two calls, refer to
"
Conference Call.
"
Place/Retrieve a Call From Hold
To put a call on hold, press the “Phone” button
until you hear a single beep. This indicates that
the call is on hold. To bring the call back from
hold, press and hold the “Phone” button until you
hear a single beep.
Toggling Between Calls
If two calls are in progress (one active and one on
hold), press the “Phone” button until you hear a
single beep indicating that the active and hold
status of the two calls have switched. Only one
call can be placed on hold at one time.
Conference Call
When two calls are in progress (one active and
one on hold), press and hold the “Phone” button
until you hear a double beep indicating that the
two calls have been joined into one conference
call.
Three-Way Calling
To initiate three-way calling, press the “Voice
Recognition” button while a call is in progress,
and make a second phone call, as described
under
"
Making a Second Call While Current Call in
Progress.
"
After the second call has established,
press and hold the “Phone” button until you hear a
double beep, indicating that the two calls have
been joined into one conference call.
Call Termination
To end a call in progress, momentarily press the
“Phone” button. Only the active call(s) will be
terminated and if there is a call on hold, it will
become the new active call. If the active call is
terminated by the far end, a call on hold may not
become active automatically. This is cell phone-
dependent. To bring the call back from hold,
press and hold the “Phone” button until you hear a
single beep.
Redial
•
Press the “Phone” button to begin.
•
After the
"
Ready
"
prompt and the following
beep, say
"
Redial.
"
•
The UConnect
!
system will call the last number
that was dialed from your cellular phone.
NOTE:
This may not be the last number dialed from
the UConnect
!
system.
Call Continuation
Call continuation is the progression of a phone
call on the UConnect
!
system after the vehicle
ignition key has been switched to OFF. Call con-
tinuation functionality available on the vehicle can
be any one of three types:
•
After the ignition key is switched to OFF, a call
can continue on the UConnect
!
system either
54