• The vehicle is in 4LO transfer case mode (if
equipped).
• The vehicle has not reached a speed of
5 mph (8 km/h) after the previous autostop.
• Outside temperature is to cold or to hot for
system to operate.
• Engine has not reached normal operating
temperature.
• Cabin heating or cooling is in process and an
acceptable cabin temperature or setting has
not been achieved.
• Many of these reasons are displayed as a
STOP/START message in the instrument
cluster display within the STOP/START sec-
tion. The system must be in the “STOP/
START READY” state to autostop. To access
the STOP/START section of the instrument
cluster display, use the display controls. Re-
fer to the “Starting and Operating” section
of your Owner’s Manual for a complete list of
possible events in which the engine does not
autostop.
How do I know I am in an autostop?
• The engine will shut down, the tachometer
will move to the zero position and the STOP/
START telltale will illuminate in the instru-
ment cluster.
How do I start the engine while in an autostop?
• While in a forward gear, the engine will start
when the brake pedal or clutch is pressed or
released or the throttle pedal is depressed.
The automatic transmission will re-engage
upon engine restart.
For further information, and applicable warn-
ings and cautions, please refer to the Owner’s
Manual
at
www.mopar.com/en-us/care/
owners-manual.html
(U.S.
Residents)
or
www.owners.mopar.ca (Canadian Residents).
Pairing Procedure
Make sure the ignition in the ACC or ON posi-
tion.
1. Press either the “Phone” button or the “Set-
tings” button in the Menu Bar on the touch-
screen.
2. From the Settings list, select “Phone/
Bluetooth,” and then select “Paired Phones
and Audio Devices.”
NOTE:
A message will display asking, “No Phone Con-
nected. Would you like to pair a phone?” Select
Yes. After pressing Yes, the radio prompts will
take you through the steps to connect your
phone via Bluetooth. Uconnect Phone will dis-
play an “In progress” screen while the system is
connecting. Once the pairing has been success-
ful, a message will display “Bluetooth pairing
successful: The device supports Phone and
Audio.” Click “OK.”
PHONE PAIRING
