Sway Bar Disconnect
Your vehicle may be equipped with an elec-
tronic disconnecting stabilizer/sway bar. This
system allows greater front suspension travel in
off-road situations.
This system is controlled by the SWAY BAR
switch located on the instrument panel (to the
right of the steering column).
Push the SWAY BAR switch to activate the
system. Push the switch again to deactivate the
system. The “Sway Bar Indicator Light” (lo-
cated in the instrument cluster) will illuminate
when the bar is disconnected. The “Sway Bar
Indicator Light” will flash during activation
transition, or when activation conditions are not
met. The stabilizer/sway bar should remain in
on-road mode during normal driving conditions.
To disconnect the stabilizer/sway bar, shift to
either 4H or 4L and push the SWAY BAR switch
to obtain the off-road position. Refer to “Four-
Wheel Drive Operation” in this section for fur-
ther information. The “Sway Bar Indicator
Light” will flash until the stabilizer/sway bar
has been fully disconnected.
To return to on-road mode, push the SWAY BAR
switch again.
For further information, and applicable warn-
ings and cautions, please refer to the Owner’s
Manual
at
www.mopar.com/en-us/care/
owners-manual.html
(U.S.
Residents)
or
www.owners.mopar.ca (Canadian Residents).
Axle Lock (Tru-Lok) — Rubicon Models
The AXLE LOCK switch is located on the instru-
ment panel (to the right of the steering col-
umn).
This feature will only activate when the follow-
ing conditions are met:
• Ignition in RUN position, vehicle in 4L (Low)
range.
Sway Bar Switch
Axle Lock Switch Panel