Jeep 2015 Wrangler, Operating Information Manual

Page: 109 / 750

CAUTION! (Continued)
freeze to the windshield, damage to the
wiper motor may occur when the vehicle is
restarted.
Intermittent Wiper System
Use the intermittent wiper when weather condi-
tions make a single wiping cycle, with a variable
pause between cycles, desirable. Rotate the
end of the lever to the first detent position for
one of five intermittent settings. The delay cycle
can be set anywhere between 1 to 18 seconds.
NOTE:
The wiper delay times depend on vehicle
speed. If the vehicle is moving less than
10 mph (16 km/h), delay times will be
doubled.
Windshield Washers
To use the washer, pull the lever toward you and
hold while spray is desired. If the lever is pulled
while in the delay range, the wiper will start and
continue to operate for two or three wipe cycles
after the lever is released, and then resume the
intermittent interval previously selected.
If the lever is pulled while in the off position, the
wipers will operate for two or three wipe cycles
and then turn off.
WARNING!
Sudden loss of visibility through the wind-
shield could lead to a collision. You might not
see other vehicles or other obstacles. To avoid
sudden icing of the windshield during freezing
weather, warm the windshield with defroster
before and during windshield washer use.
Mist Feature
Push down on the wiper lever to activate a
single wipe to clear off road mist or spray from a
passing vehicle. As long as the lever is held
down, the wipers will continue to operate.
NOTE:
The mist feature does not activate the
washer pump; therefore, no washer fluid will
be sprayed on the windshield. The wash
function must be used in order to spray the
windshield with washer fluid.
Front Wiper Control
Mist Control
106