Jeep 2015 Wrangler, Operating Information Manual

Page: 105 / 750

Headlights With Wipers (Available
With Automatic Headlights Only)
When this feature is active, the headlights will
turn on approximately 10 seconds after the
wipers are turned on if the multifunction lever is
placed in the AUTO position. In addition, the
headlights will turn off when the wipers are
turned off if they were turned on by this feature.
The Headlights with Wipers feature can be
turned on or off through the Electronic Vehicle
Information Center (EVIC) — if equipped. Refer
to
“Electronic Vehicle Information Center
(EVIC)/Customer-Programmable Features” in
“Understanding Your Instrument Panel” for fur-
ther information.
Turn Signals
Move the multifunction lever up or down and the
arrows on each side of the instrument cluster
flash to show proper operation of the front and
rear turn signal lights.
NOTE:
•
If either light remains on and does not
flash, or there is a very fast flash rate,
check for a defective outside light bulb. If
an indicator fails to light when the lever is
moved, it would suggest that the indicator
bulb is defective.
•
A tone will chime if the turn signals are
left on for more than 1 mile (1.6 km).
Lane Change Assist
Tap the lever up or down once, without moving
beyond the detent, and the turn signal (right or
left) will flash three times then automatically
turn off.
Lights-On Reminder
If the headlights or parking lights are on after the
ignition is turned OFF, the high beam indicator
light will remain illuminated and a chime will
sound when the driver’s door is opened.
High/Low Beam Switch
Push the multifunction lever away from you to
switch the headlights to high beam. Pull the
lever toward you to switch the headlights back
to low beam.
Front Fog Lights — If Equipped
The front fog light switch is in the multi-
function lever. To activate the front fog
lights, turn on the position lights or head-
lights and pull out the end of the lever.
Turn Signal Operation
102