QUATTRO
Rev. A
2012-09-10
Service manual
23
7.6 Replacing the pump (built-in cold water tank)
Remove the upper and lower
casings.
Loosen the pump’s electrical
connections (1, figure 30).
Remove hose (2) between pump
and heater tank.
Remove the pump from its inlet
(3).
Mount the new pump in reverse
order. Note the colour markings
on the cable clips (1).
1.
2.
3.
4.
5.
7.7 Replacing the whipper motor
Open the front of the machine
Remove the funnel (2), mixer bowl
(4), whipper (3) and the fixing
plate for the mixer bowl
(1, figure 31).
Loosen the fixing screw (5, figure
32) for the whipper motor.
Press lip (6) downward and lift out
the whipper motor. Disconnect the
motor’s electrical connections.
Note the cable connections.
When replacing the whisk motor,
also replace the seal for the whipper
axle or alternatively the complete
fixing plate.
Mount the new motor in reverse
order.
1.
2.
3.
4.
5.
6.
Note the cable connections
concerning positive/negative
pole.
1
2
3
Figure 30
1
2
3
4
Figure 31
Figure 32
5
6
Summary of Contents for QUATTRO
