Jeanneau MERRY FISHER 855 OFF SHORE, Owner'S Manual, Page: 46 / 108

42/104
ANCHORING BY HAND WITH USE OF A MANUAL WINDLASS
- Release the windlass brake using the handle located in the chain locker so as to allow
the chain lifter to turn freely and to release the anchor from the stem fitting
- Re-engage the brake and let the anchor hang until the mooring position is reached.
- Have the boat pointed into the wind and without speed.
- Release the brake and pay out the chain slowly.
- Control the speed of anchor lowering using the brake.
- Once the anchor has taken hold re-engage the brake and secure the hawser to the
cleat.
HEAVING UP THE ANCHOR
- Lock the cable lifter snubber.
- Ensure the chain is properly set on the cable lifter.
- Slowly go near the anchor, using your engine (Don't use your windlass to winch the
boat).
- Heave the anchor completely.
- Visually check the last meters till the anchor gets into contact with the davit.
- If you just change berth, check the position of the anchor on the stem fitting.
- For sailing, store the anchor in the chain locker or fasten the anchor to its roller.
- For electrical windlasses cut off the power supply as soon as the anchor has been
lifted.
STERN ANCHORING
Stern anchoring shall be performed with the engine declutched.
- Secure the required length of cablet on the mooring cleat.
- Pay out the anchor line slowly.
- Be careful not to damage the propeller or driving shaft.
ADVICE - RECOMMENDATION
- After each trip rinse the windlass and anchor chain or rode with fresh water.
- Check the swinging area once the boat is at anchor.