To fit the front and rear wheels remove the nut and outer washer from the front axle. Put the smaller
front wheel, washer and locking nut onto the front axle and tighten the nut with a spanner, Do not
over tighten, this may stop the wheel rotating (Fig. 8).
Place the larger rear wheel onto the rear axle and put a split pin into the hole in the rear axle (Fig. 9).
With a screwdriver, split the two legs on the split pin to secure the wheel (Fig. 10). Fit the centre wheel
trim to all four wheels (Fig. 11). Your machine is now complete.
INSTALL ATTACHMENTS
Please note your lawn mower may have been shipped with the mulching plug already fitted under
the rear grassbox flap. The mower has three different operating modes.
COLLECTING:
Fit the grassbox by lifting the rear flap on the mower and hook the front of the box to the shaft on the
mower. Lower the flap to lock the grassbox in position.
When the box is full, the grass will be visible through the viewing window in the top of the box.
Stop the engine before emptying the grassbox.
REAR DISCHARGE:
With the grassbox removed and the rear flap in the down position, the mower will cut and discharge
the grass from the rear of the machine.
MULCHING:
Fit the mulch plug to the rear discharge opening of the mower and close the rear flap.
The mower will now recycle the chopped grass into the lawn surface.
To mulch efficiently only cut one third of the length of the grass.
8
9
10
11