BEND 3:
At this step you may want to use a large 90
o
square to help position the template. Position the template above
the rollbar tube with the template line facing up towards the top of the rollbar as shown in to the right. Slide the
template up or down the rollbar tube until its outside is 31” from the rollbar’s center. Mark your tube and make
the bend.
BEND 4:
Position the template with the template line facing up towards the top of the rollbar as shown to the right. Slide
the template up or down the rollbar tube until its outside is 62” from the outside of the 3rd bend. Also, verify the
bend is the same distance down the tube from the top of the rollbar. If all is correct mark the tube and make the
bend.
Lastly, cut the ends of the tube to make the rollbar 40” tall and your done.
31”
Template positioned for the 3rd bend.
62”
Template positioned for the 4th and last bend.
Template’s reference line
Template’s reference line
Page 19
