JCM UBA Pro RQ Series, Integration Manual

Page: 20 / 58

P/N 960-000209R_Rev. A © 2019, JAPAN CASH MACHINE CO., LTD.
1 0
Section 3 UBA Pro RT/RQ™ Series Banknote Recycler Installation
Bottom Installation (For Standard
Installation Type Only)
When a bottom mounting configuration is preferred,
perform the following procedure:
1. From Inside:
Secure the inside of the RT/RQ Bottom Frame
into its intended location using four (4) M4
Screws (Figure 7 a
1
through a
4
).
From Outside:
Secure the outside of the RT/RQ Bottom Frame
into its intended location using the four (4)
threaded φ 4 Studs (Figure 7 b
1
through b
4
).
Bezel Installation
1. Secure the Bezel (Figure 8 a ) using two (2) speci-
fied Screws (Figure 8 b
1
& b
2
).
External Harness Installation
1. Pug in the Power Cable (Figure 9 a ) and the
Interface Harness (Figure 9 b ) into each Connec-
tor.
2. Secure the Connector (Figure 9 c ) using two (2)
specified Screws (Figure 9 d
1
& d
2
).
Cash Box Lock Installation
One or two security locks can be installed onto a
Cash Box. When installing a security lock, the fol-
lowing attachment accessories may be required:
•
Two Key Spacers
•
Plate Lock Keys
•
Key Cap Attachment.
Caution: This installation is allowed only
when the RT/RQ unit is used as Standard
installation.
NOTE: Prepare the following Screw:
•
From Inside: M4 Screw
•
From Outside: φ 4 Stud (the maximum length
of each Stud should not extend more than
10mm long from the inside of the Bottom
Frame
•
Tightening Torque: 120N·cm
Figure 7 Bottom Installation (Standard Installa-
Figure 7 Bottom Installation (Standard Installation
Type)
a
1
a
2
a
3
a
4
b
1
b
2
b
3
b
4
NOTE: Prepare the following Screw:
•
M3x16 Screw (provided)
•
Tightening Torque: 60N·cm
Figure 8 Bezel Installation
Figure 8 Bezel Installation
b
1
a
b
2
NOTE: Prepare the following Screw:
•
M3x12 Screw (provided)
•
Tightening Torque: 80N·cm
Figure 9 External Harness Installation
Figure 9 External Harness Installation
d
1
d
2
a
b
c
Figure 10 Key Hole Location
Figure 10 Key Hole Location
Key Holes