1 - 6
CHAPTER 1
Product Name & Product Specifications
5. General Specifications
5-1
Size of Banknotes
Width: 62 to 85 mm, Length: 120 to 160 mm
5-2
No. of Denominations
Up to 32 denominations
[Refer to "Data Setting Specifications" of each software]
5-3
Directions
4 ways (Longitudinal insertion)
(The directions may vary depending on the software specifications.)
[Refer to "Data Setting Specifications" of each software]
5-4
Acceptance Rate
95% or more (Including bills accepted in two retries. The following
bill is excluded:)
(1) Bill with stain, wear, wetness, tear or remarkable wrinkles
(2) Bill with folded corner or edge
(3) Bill with incorrect cut dimensions or improper alignment in printing
5-5
Processing Speed
Approx. 2 seconds for validation. Approx. 5 seconds for stacking (with
SD3 stacker)
For a head unit without SD3 stacker, it takes approx. 3 seconds from
acceptance to ejection.
5-6
Interface
(1) TTL serial interface
(2) MDB interface
(3) ccTalk / HII interface
(4) Parallel interface
Should be connected to an optional I/F conversion board.
5-7
Stacker Box
(1) Capacity
Approx. 400 bills
(2) Access
Front Access
5-8
Escrow
1 Bill
5-9
Indication
(1) The validator operating status is indicated by three LEDs (green,
red and orange) on CPU board.
Green LED: This LED lights during idling and bill-accepting
operation. When a bill is rejected, the LED blinks to
indicate the rejecting status (see Chapter 6, 6-11/12).
Red LED:
This LED blinks when an error is detected.
The error status is indicated by the number of blinks
(see Chapter 6, 6-11).
Orange LED: This LED lights when the guides of bill centering
mechanism are at the home position. While the LED is
on, the head unit can be opened.
(2) External display output (7-pin connector)
When this connector is connected to the optional display unit, the
acceptor’s operating status is displayed.
ON:
The unit is able to accept bills.
OFF:
The unit is unable to accept bills.
