JCM GLOBAL UBA Pro RT Series, Operation And Maintenance Manual

Page: 102 / 196

P/N 960-000213R_Rev.A © 2020, JAPAN CASH MACHINE CO., LTD.
6 - 1 0
Section 6 UBA Pro RT/RQ™ Series Banknote Recycler Calibration and Testing
Note Position Sensor 1-3 Test
To perform the Note Position Sensor 1 through 3
Test on the RT Transport side, proceed as follows:
1. Ensure that the Recycler and Cash Box is prop-
erly installed.
2. Launch the Performance Test Program (see
page 6-7).
3. Select “
TWIN_POSITION_SENSOR_TEST1
”
(Figure 6-43 a ).
4. Click the “
Start
” Screen Button (Figure 6-
43 b ) to begin the Test.
5. Follow the procedures below.
6. Confirm the “
ON/OFF
” indication (Detected/
NOT Detected) appeared in the “
RC-Position
sensor 1 (RC-Twin)
” area (Figure 6-44 a ).
7. Click the “
Stop
” Screen Button (Figure 6-
44 b ) to end the test.
Note Position Sensor A-C Test
To perform the Note Position Sensor A through C
Test on the RT Transport side, proceed as follows:
1. Ensure that the Recycler and Cash Box is prop-
erly installed.
2. Launch the Performance Test Program (see
page 6-7).
3. Select “
TWIN_POSITION_SENSOR_TEST2
”
(Figure 6-45 a ).
4. Click the “
Start
” Screen Button (Figure 6-
45 b ) to begin the Test.
5. Follow the procedures below.
6. Confirm the “
ON/OFF
” indication (Detected/
NOT Detected) appeared in the “
RC-Position
sensor 2 (RC-Twin)
” area (Figure 6-46 a ).
7. Click the “
Stop
” Screen Button (Figure 6-
46 b ) to end the test.
Test Item
Procedure
Note Position Sensor 1
Remove the Recycler
↓
Open/close the Front Transport to
cover/uncover each Sensor
Note Position Sensor 2
Note Position Sensor 3
Remove the Transport Unit
↓
Cover/uncover the Sensor
Figure 6-43 Note Position Sensor 1 -3 Test 1
Figure 6-43 Note Position Sensor 1 -3 Test 1
a
b
NOTE: Refer to “Sensor, Roller and
Belt Locations” on page 2-16 for the
detailed Sensor locations.
Front
Transport
Position
Sensor 3
Transport
Unit
Figure 6-44 Note Position Sensor 1 -3 Test 2
Figure 6-44 Note Position Sensor 1 -3 Test 2
a
b
Scroll
Test Item
Procedure
Note Position Sensor A
Remove/reseat the Recycler to
cover/uncover the Sensors.
Note Position Sensor B
Note Position Sensor C
Figure 6-45 Note Position Sensor A -C Test 1
Figure 6-45 Note Position Sensor A -C Test 1
a
b
NOTE: Refer to “Sensor, Roller and
Belt Locations” on page 2-16 for the
detailed Sensor locations.
Figure 6-46 Note Position Sensor A -C Test 2
Figure 6-46 Note Position Sensor A -C Test 2
a
b
Scroll