JCM GLOBAL UBA Pro RT Series, Operation And Maintenance Manual

Page: 99 / 196

P/N 960-000213R_Rev.A © 2020, JAPAN CASH MACHINE CO., LTD.
6 - 7
Calibration and Testing UBA Pro RT/RQ™ Series Banknote Recycler Section 6
Launch Performance Test Program
To launch the Performance Test program, proceed
as follows:
1. Remove electrical power.
2. Set each DIP Switch of the UBA Pro and the RT/
RQ as below (Figure 6-28).
3. Connect the Unit to the PC.

(Refer to Figure 6-1 for the Tool Requirements
and Harness Connector locations).
4. Apply electrical power to the Unit.
5. The UBA Pro’s Green and Red Status LEDs will
be lit.
6. Launch the “
JCM Tool Suite Standard Edition
”
Application.
7. Click and hold-down the “
Service Mode
” Pull-
Down Menu.
8. Select “
Performance Test
” (Figure 6-29 a ).
9. The Performance Test Main Screen will appear
(Figure 6-30).
Status LED Test
To perform the Status LED Test, proceed as fol-
lows:
1. Launch the Performance Test Program (see
page 6-7).
2. Select “
RC_COLLECT_AND_LED_TEST
” (Fig-
ure 6-31 a ).
3. Click the “
Start
” Screen Button (Figure 6-
31 b ) to begin the Test.
4. Press the Status LED/Collect Button (Figure 6-32
a ).
5. Confirm that the Status LED is lit in the follow-
ing sequential order each time when pressing the
Status LED/Collect Button:

Green => Magenta => Cyan => Blue
=> Yellow => Red => White =>
OFF
6. Click the “
Stop
” Screen Button (Figure 6-
33 a ) to end the test.
Figure 6-28 Launch Performance Test Program
Figure 6-28 Launch Performance Test Program 1
DIP Switch #8 ON
DIP Switches All OFF
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
Figure 6-29 Launch Performance Test Program
Figure 6-29 Launch Performance Test Program 2
a
Figure 6-30 Launch Performance Test Program
Figure 6-30 Launch Performance Test Program 3
Figure 6-31 Status LED Test 1
Figure 6-31 Status LED Test 1
a
b
Figure 6-32 Status LED Test 2
Figure 6-32 Status LED Test 2
a
Figure 6-33 Status LED Test 3
Figure 6-33 Status LED Test 3
a