54
Keeping the Outside of JCB Toughphone Clean
Clean JCB
Toughphone immediately if it comes into contact with any
contaminants that may cause stains, such as ink, dyes,
makeup, dirt, food, oils, and lotions. To clean JCB
Toughphone, unplug all cables and turn off JCB Toughphone.
Then use a soft, slightly damp, lint-free cloth. Avoid getting
moisture in openings. Don’t use window cleaners,
household cleaners, aerosol sprays, solvents, alcohol,
ammonia, or abrasives to clean JCB Toughphone. The front
screen surfaces have an oleophobic coating. To remove
fingerprints, simply wipe these surfaces with a soft, lint-free
cloth. The ability of this coating to repel oil will diminish
over time with normal usage, and rubbing the screen with
an abrasive material will further diminish its effect and may
scratch the glass.
Dust and Water
The JCB Toughphone in fully tested to
meet either IP54 or IP57 specifications (depending on the
model). It is very important to note that all of the
Toughphone connectors, covers and battery compartment
must be correctly fastened and have the correct 0-rings
fitted to meet the waterproof and dust specifications Failure
to ensure all connector, covers, battery compartment and O
rings are correctly fitted will invalidate the warranty. In
case JCB Toughphone gets wet turn off JCB Toughphone
before cleaning, and allow it to dry thoroughly before
turning it on again. Do not attempt to dry JCB Toughphone
with an external heat source, such as a microwave oven or
hair dryer.