JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0333 0143092
continually blow dust away from the
cutting area.
14. WORK LIGHT
Press the on/off switch (1), the work
light (14) will illuminate. Release the
on/off switch to turn off the work
light.
CAUTION:
Do not look into
the strong light or see the
source of light directly.
WORKING HINTS FOR
YOUR JIGSAW
If your jig saw becomes too hot,
especially when used at low speed,
set the speed to maximum and run
no Load for 2-3 minutes to cool the
motor. Avoid prolonged usage at
very low speeds.
GENERAL
Always use a blade suited to the
material and material thickness to
be cut. Always ensure the work–
piece is firmly held or clamped
to prevent movement. For easier
control, use low speed to start
cutting, then increase to correct
speed.
Any movement of the material may
affect the quality of the cut. The
blade cuts on the upward stroke
and may chip the uppermost
surface or face of the work piece.
Ensure your uppermost surface is a
non-visible surface when your work
is finished.
CUTTING LAMINATES
Use a fine tooth blade when cutting
most laminates and thin wood
materials. To reduce edge chipping,
clamp pieces of waste wood at both
ends on both sides and cut through
the waste wood during cutting.
CIRCLE CUTTING
Do not use the pendulum action
