JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0333 0143092
MAINTENANCE
Remove the plug from the socket before carrying out any adjustment, servicing
or maintenance.
There are no user serviceable parts in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean. Keep all working controls
free of dust. Occasionally you may see sparks through the ventilation slots. This is
normal and will not damage your power tool.
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
TROUBLESHOOTING
1. If your power tool does not start, check the plug on the power supply first.
2. If your hammer becomes too hot in use, set the hammer switch to the drill mode
and allow your drill to operate at maximum speed without load for 2 minutes.
3. If your hammer work efficiency is too low, please add sufficient grease in the grease box.
4. If your hammer work efficiency is too low please check drill bit or chisel and make
sure it is not blunt or worn.
5. If a fault can not be rectified, return the tool to an authorized dealer for repair.
ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authorities or retailer
for recycling advice.
Summary of Contents for JCB-SDS920
Page 2: ......
