13
JCB-ID1050
Instruction & User Manual
Hammer Drilling Mode
m
Set the mode selector switch to hammer
mode to enable the hammer function. The
hammer function allows more effective
drilling into hard, brittle materials such as
concrete, brick and stone.
Gearbox Speed Control
Only use the speed control switch when the
tool is stopped and the chuck is not rotating.
Otherwise the tool can be damaged.
WARNING!
m
Rotate the speed control switch to position
1 for low speed (0 to 1100rpm).
m
Use the low speed mode for high torque
applications like drilling holes with a large
diameter.
m
Rotate the speed control switch to position
2 for high speed (0 to 3000 rpm).
m
Use the high speed mode for low torque
applications like drilling small holes.
Maintenance
Switch off the tool and disconnect the power
(remove battery/unplug) before cleaning
and maintenance – risk of electric shock and
accidental start.
WARNING!
m
Wipe the tool with a dry or damp cloth. Do
not use a wet cloth. Do not use detergent
that contains solvent or corrosive, abrasive
additives – risk of damaging the surface.
m
Keep the ventilation openings open – risk of
overheating.
m
Clear the tool vents and the accessory
mount of dust and dirt after each use. Do
not clean ventilation holes by inserting sharp
objects into them.
m
Stubborn contamination in areas hard to
access can be removed with compressed air
(max 3. bar).
m
Regularly check all fasteners, screws and
bolts to make sure that they are tight.
Tighten any loose screws immediately –
serious injury could occur.
m
If the power cord becomes damaged and
replacement is necessary, this must be
carried out by an authorised warranty agent.
Never open the tool. The tool has no
internal parts that the user can service or
repair. Never try to repair the tool yourself.
WARNING!
Transport and Storage
m
If the tool shall remain unused for any
length of time, it should be stored in the
original packaging.
m
Store the tool in a dry, frost-free, well
ventilated place with a temperature of no
more than 40°C and out of the reach of
children.
m
Always Switch off the tool and disconnect it
from the power supply (remove the battery/
unplug the power cord) before transport.
m
Always carry the tool using the purpose-
designed handle.
m
Always carry the tool using the purpose-
designed handle.
m
Ensure that the tool is not at risk of tipping
over or exposed to vibration and shocks
during transport, especially if the tool will be
transported by car or other vehicle.
