jcb JCB-18MT, Instructions & User'S Manual

Page: 16 / 21

16
JCB-18MT
Instruction & User Manual
Intended Use
Multi-function tool for a variety of different DIY
jobs, such as drilling, sanding, sawing, screw
driving and cutting.
The tool must not be modified or used for
any other purposes than the ones described in
these instructions.
Battery
Make sure the power switch is not pressed
in when inserting or replacing the battery.
NOTE
m
Do not force the battery when
connecting it, use moderate pressure.
An incorrectly connected battery can
damage the battery terminals or the battery
socket on the tool.
m
Use the “Press” button on the battery
to check the charging status; 4 red LEDs
indicates fully charged, where 1 indicates
low battery status.
Charging The Battery
m
After charging for the first time, use the tool
until the battery is completely discharged.
m
Repeat this charging and discharging cycle 4
to 5 times.
If the LEDs on the charger do not come on
when charging:
m
Check that the charger’s mains adaptor is
properly plugged into the power point and
that the charger is switched on
m
Check that the battery is correctly inserted
in the charger
m
Place the battery charger on a level and
stable surface. Plug the charger into a 230 V
power point.
m
Connect the battery to the charger so that
it clicks into place. The red LED lights up on
the charger when correct contact is made.
m
When the battery is fully charged, after
about 45 minutes, the red LED goes off and
only the green LED stays on.
m
Unplug the charger from the power point
and remove the battery from the charger.
Connecting the battery
m
Connect the battery to the battery socket
on the tool so that it clicks into place.
Removing the battery
m
Press the battery lock and remove the
battery from the tool.