8
The suction power can also be adjusted using
the fingertip air flow control on the hose handle
F
.
Closed: full suction
Open:
low suction
TheRmosTAT
pRoTeCTIon
If the motor overheats, the cleaner will switch
off automatically. If this occurs, press the on/
off switch, disconnect from the mains supply
and leave for 60 minutes to allow the motor to
cool down.
The likely causes of the cleaner overheating are:
• The nozzle or tubes are blocked
• The dustbag is full
• The motor protection filter
‡
is very dirty
• The exhaust filter
Ê
is very dirty.
Check and rectify the problem before
attempting to reuse the cleaner.
NOTE:
Do not use your vacuum
cleaner without the filters fitted.
TUBe sTAnDBY
During short breaks in cleaning, the tubes can
be held in an upright ‘standby’ position, whilst
you move furniture for instance
G
.
CAUTION!:
Ensure that the
appliance is never left unattended
whilst it is switched on.
CABle RewInD
Switch off the appliance. Remove the plug from
the mains supply and rewind the power cable
using the cable rewind switch
 H
.
WARNING!: When using the
cable rewind, always hold the
plug as the cable will rewind
quickly.
sToRAge
Tube park
The vacuum cleaner can be stored in an upright
position. Rotate the floor nozzle until the lug on
the back of it can be fitted into the tube park
slot
Ï
on the base of the appliance
I
.
F
G
H
I
OPEN
CLOSED